Dye stool: drilling slope method and separator

While building stools using the maple cabin sections of the legs, I reached the drilling point for the curtains. The four legs were irregular in the width and looked out of the plane in all directions. You need to dig holes through each of the four leg pairs. As for the stick chairs, I will record a straight straight path for the leg of the legs and the evaluation fold, but this did not succeed well for these actual sticks.

The solution that I reached is a double: a slope of drilling and a system of guidance bars and separators on the match. First, I measured the corner of the fist of my Milwaukee exercises during its fuel on the gentle flat bottom battery and made a slope to face the angle. He silenced a length of the drilling rod in the drilling and stood on the bench. There is little flexibility in the battery connection, so I felt what it is and aimed at half. Then I installed vertical support in the binding and tied the exercises towards it until I thought I was there. Support kept everything stable when I reviewed the angle.

I used the Wixey digital angle scale and a level to measure it at 13.4 degrees. The built -in magnet makes life easy. You can manually measure by taking vertical measurements in Chuck and at the end of the penis, draw them on paper and use the moving. Place your angle on a long block, cut it in Bandsaw, and clean the surface. I ran me over the fire before cutting it into length. If we look back, I think a fast layer of something would help the tape better.

The bottom of the drilling is covered with a painter tape, and the two -sided tapes intended to secure the elements on the CNC table, the exercises on the slope road. The exercises should be perfectly concentrated by one side to the side of the slope road because the edge of the slope is used to register both from left to right to right to the left. I used the pieces of cutting the slope to put it under the pits while preparing to prevent it from peeling itself from the slope road. (Ask me how I learned this!)

I installed a railway on the edge of the seat. It should be thick enough to allow the addition of breaks under the pits to change the height to separate the stoves from the front alongside the side. For this stool, you drilled SS holes with drilling on ½ in. Riser and FB holes with stool on ½ in. The riser, gave me an inch of displacement between the vertical centers. I think I wish the final piece better with more displacement.

The bit was shocked by a small point in the pits and pressed a pair of legs on the railway. Then the exercises were presented to its leg by moving it along the railway. If the leg is not landed, you would need to add breaks either to the drilling or leg to reach them.

With the focus of the thing, I moved to the other side and repeated the process. I went back and forth until the pits hit dead nuts on both sides using the same separator for the coach. (Leg breaks can only differ.) The legs are now assigned with drilling points in parallel with railways and the interrelated lines with each other. I added some weight to the top to help keep the chair in place and dig it from both sides. A little harsh wire tells the story …

If you know anything you will use in articles, it will never be easier to dig it from now. Use the same breaks and follow the experimental holes before moving to the other three sides. As a reward, the drilling moves from the outside from every hole in each leg most of the potential explosion to the inner, less clear inner side of the joints.

Building a classic kitchen seat

The building of Windsor and modern tools give the outcome of the immortal.

Easy angle holes on the drill piston

Jig Beth Ireland cancels the need to create multiple angle drilling platforms for your drilling pressure.

Dual -level drilling printing table

Benchtop’s old drilling presses are great, so that you have to move the table. In this video, Ben Strano has a simple solution that has always added some storage that works.